Photography Light Box

Here is a simple photography light box that was constructed out of foam core board. The frame was cut out using a rotary cutter:

IMG_4140

The foam core was then assembled using a hot glue gun:

IMG_4143

The holes in the box were covered using parchment paper. The paper was pinned to the box instead of glued so it can be replaced if it turns yellow over time. A set of three 100 watt incandescent light bulbs were used. One bulb was placed in a desk lamp above the box. The other two were attached to some simple 2×4 frames on the right and left of the box. Here are some action shots:

IMG_4144 IMG_4149

Here are some resulting photos:

IMG_4603 IMG_4616 IMG_4156

Advertisements